Hardware overview (IFP50-5)
Welcome to ViewBoard and your newly acquired interactive flat panel (IFP). Your ViewBoard IFP50-5 series comes with various components to assist in connecting devices and enhance your usage of the ViewBoard.
This article introduces the basics of the IFP50-5's additional hardware, as well as give an overview of the display's control panel and ports.
Equipment basics
The following items are included in your IFP50-5's packaging:
What comes with your ViewBoard
 Pen stylus (2x)
|
 Remote control
|
 AAA batteries (2x)
|
 RS-232 adapter
|
 Power cable
|
 HDMI cable (3m/10ft)
|
 USB cable for touch (3m/10ft)
|
 Clamp (5x)
|
 Webcam plate
|
 Webcam screws(M4 x 6mm 2x; M3 x 6mm 2x) |
 Wall mount screws(M8 x 25mm 4x) |
 Compliance Statement
|
 Quick Start Guide
| |||
Wall mount kit specifications (VESA specs)
The following are some specifications for wall mounting an IFP50-5. For specific wall mount or mobile mount bracket installation steps, please review your IFP50-5's Quick Start Guide wall mount installation guide. If attaching to other building materials, please contact your nearest dealer.
5550-5
Rear panel with VESA spec measurements highlighted. Refer to the table below for corresponding measurements.
6550-5
Rear panel with VESA spec measurements highlighted. Refer to the table below for corresponding measurements.
7550-5
Rear panel with VESA spec measurements highlighted. Refer to the table below for corresponding measurements.
8650-5
Rear panel with VESA spec measurements highlighted. Refer to the table below for corresponding measurements.
Model |
VESA Spec. (A x B) |
Standard Screw (C x D) |
Quantity |
|---|---|---|---|
| IFP5550-5 | 400 x 200 mm | M8 x 25 mm | 4 |
| IFP6550-5 | 800 x 400 mm | M8 x 25 mm | 4 |
| IFP7550-5 | 800 x 400 mm | M8 x 25 mm | 4 |
| IFP8650-5 | 800 x 600 mm | M8 x 25 mm | 4 |
WARNING
Do not use screws that are longer than the standard dimension listed above. Using alternative screws may cause damage to the inside of the panel.
IFP50-5 controls and ports overview
This section breaks down the details of different input/out (I/O) ports and controls located on the IFP50-5.
Front panel of the IFP50-5 with input/output (I/O) ports and control panel areas highlighted.
Control panel
The control panel and front input/output (I/O), found on the bottom-right corner of the front of the IFP50-5, contains basic commands for the device and USB ports.
Refer to the below table below for function details.
Button/Port |
Function |
|
|---|---|---|
| 1 | Ambient Light Sensor | Monitor a room's ambient light. |
| 2 | Remote control receiver | Receives commands from the device's remote control. |
| 3 | Power indicator |
|
| 4 | Home | Return to the ViewBoard's home screen. |
| 5 | Return | Return to the ViewBoard's previous screen. |
| 6 | Settings |
|
| 7 | Decrease volume | |
| 8 | Increase volume | |
| 9 | USB |
|
Input/output panels
Your IFP50-5 comes with multiple input/output (I/O) panels. The ports on these panels provide different ways to connect external devices by cable.
Overview of I/O panels located on different parts of the device.
Port |
Function |
|
|---|---|---|
| 1 | TOUCH 1 | Touch signal output to external PC device. Pair with HDMI 1 or HDMI 2 to navigate an external device with touch. |
| 2 | HDMI 1/2/3 | High-definition input; connect to a PC (or other device) with an HDMI output. Note: HDMI 1 supports HDMI CECC. |
| 3 | TOUCH 2 | Touch signal output to external PC device. Pair with HDMI 3 to navigate an external device with touch. |
| 4 | USB Type-C |
|
| 5 | USB Type-A | Connect USB devices such as a hard disk, keyboard, mouse, etc. |
| 6 | SPDIF | For transmitting digital audio signals. |
| 7 | HDMI OUT | Connect to devices to display content from your IFP50-5 to it. |
| 8 | AUDIO OUT | Audio to an external speaker or sound system. |
| 9 | LAN |
|
| 10 | RS-232 | Serial interface; used for mutual transfer of data between devices. |
| 11 | AC IN | AC power input. |
| 12 | Power switch | Turn AC power supply ON/OFF. |